Glass Door Cooler
1 How to maintain glass door coolers
Water accumulated in the drain tank melted ice It flows through the drain and flows into the water tray.
Don't forget to dispose of the water in the tray. at least once a day
However, the amount of drainage may increase depending on the usage and environmental conditions. The amount of water in the water tray should be checked according to the usage situation.
2 Clean the door panel
Prepare a soft cloth and warm water. Keep the packaging clean at all times. If you are cleaning food scraps or juice, do not use alcohol to clean it because it will damage the cabinet panel quickly. Dirt on the packaging surface should be wiped with a cloth dampened with warm water. If there is a lot of dirt, use a neutral detergent. Regular cleaning will make the packaging last longer.
Note Do not use solvent based detergents (such as Magiclin) asthey may deteriorate the resin parts and cause cracks/cracks.Wiping the dirt inside can damage the packaging.Any remaining water on the packaging surface should be wiped off with a dry cloth.
3 Cleaning
Rack and prepare soft cloth and warm water. Always keep the shelves clean.Keeping it clean will make the shelf last longer.
Wipe the shelf with a cloth dampened with warm water. Note: Do not use solvent based detergents (such as Magiclin). Resin parts may deteriorate and crack/crack may occur.For cleaning, wipe with a cloth dampened with warm water or dishwashing detergent diluted with water. and finish by using a dry cloth to wipe.
Clean the inside and outside of the refrigerator. Prepare a soft cloth and warm water to wipe clean. Always keep the product clean. Keeping it clean will make the product last longer.
Doors and handles are easy to get infected with. Wipe off with a soft, dry cloth. If soiled, wipe with a cloth dampened with warm water or dishwashing liquid diluted with water. Do not scrub exterior surfaces with cleaners, scouring brushes, or sponges as they will scratch.
Doors and handles are easy to get infected with. Wipe the surface of the product with a dry cloth. Open the door and wipe the inside of the refrigerator with a damp cloth, followed by a dry cloth.
If very dirty, wipe with a cloth dampened with warm water or dishwashing detergent diluted with water. and finish by using a dry cloth to wipe. Note: Do not use such as Magiclin) to wipe clean.
Resin parts may deteriorate and cracks/cracks may occur. Do not use acidic cleaners, benzene, benzene, thinners, boiling water, etc. (because they will deteriorate the electrical insulation performance).
4 To install/replace LED lights,
press the switch to "OFF" when not using fluorescent lamps at night. It will help save energy.
This product uses special LED lamps, can not use ordinary LED lamps and fluorescent lamps or other lamps. If not installed correctly, the light may not light up. Otherwise, it may cause electric shock or fire.
Therefore, use the LED lamp specifically for this product.To install or replace a light bulb You should ask the distribution company.
Open Showcase
1 Installation precautions
In case of installing Showcase, always check the following topics.
Make sure there is enough space left for heat dissipation.
Please prepare a ventilation fan for cooling.
Should not be installed in windy areas or near air conditioners or outlets If installing the product in a windy area or at high temperature This may slow down the refrigerator or cause damage easily.
For floor installation, please install in a durable and flat area.
* Weather conditions outside: temperature 27℃, humidity 70％, wind force less than 0.2m/s,
2 Caution about drainage devices
About drainage
Times for product equipped with drainage device If the installation environment is not good (humidity greater than 80％, wind power greater than 0.2m/s), drainage management is required as the amount of water discharged increases. Drainage should handle the pending tray or bucket that day, more than 1 day.
How to clean the drainage channels.
Should clean the drain hole 3 months / 1 time
should wipe the dirt on the drain hole with a cloth by removing the bottom sheet by following the steps below.
3 About cleaning the drain device or tray
If not regularly maintained This may cause the drain water to overflow the tray and produce foul odors, mold or bacteria due to the deterioration of the draining device.
(A) Daily care (3 months / 1 time)
Prepare a neutral solution. with concentrations 2-3 times more than the standard in the tank and wash the drainage device After that, rinse the liquid attached to the draining device thoroughly.
(B) In case of bad smell or very dirty (6 months / 1 time)
after washing with neutral solution Should be immersed in the standard chlorine solution for approximately 5 minutes, after that rinse the solution attached to the drain device with clean water.
4 Cleaning the Condenser filter
The most common cause of malfunction of the Showcase is the clogging of the dust air-cooled condenser filter. If the filter is clogged with dust or dirt Not only will the cooling capacity decrease. but also cause the refrigerator to malfunction. and in the event that the cabinet is very damaged There may be unexpected expenses such as replacing the refrigerator. Schedule regular cleaning and cleaning every 1 to 2 weeks.
Remove the Showcase's bottom skirt panel in
case there are fewer alarms or coolers. Please check the dirtiness of the Condenser filter first.
Remove the Condenser filter.
In case of removing trash from the Condenser, gloves should be worn as well. If touching the Fin directly by hand, it may be cut. In the case of a vacuum cleaner. Ask to use a vacuum cleaner directly.
in the case of washing with water After cleaning, wait for it to dry before installing.
5 Honey comb cleaning
If the honeycomb is clogged with dust, the power of the air curtain is reduced, reducing the cooling power. And pay 5-10% more electricity per year and cause more water droplets stuck in the ceiling inside the cabinet. May cause problems with the food inside the cupboard. Should be cleaned regularly for 6 months / 1 time to save electricity costs. How to Clean the Open Showcase
Honeycomb Cover a piece of cloth or vinyl to prevent food dust.
and remove the honeycomb Please take it out from the bottom using both hands. The vents in the shape vary Showcase Showcase, each with a different material such as width, length.
If the dust off. And wash water from the opposite side to the dirty side will come out easier.
less dirty cases Dust should be vacuumed using a vacuum cleaner.
Remove the water and dry it by lightly tapping the washed honeycomb. And put it back.
Showcase each with a different width, length, cleaning and installation of beehives should be
6 taken out and dried.
In the case of a wall-mounted cabinet (shown from the side), there Should be an empty space away from the wall for heat dissipation.
Warm air from outside destroys the air curtain, possibly reducing the refrigerator or the drained water overflowing the tray.
The wind of the air conditioner destroys the air curtain, causing the refrigerator to become less.
How to clean the drain
1 Lift the suction panel up.
2 Pull the bottom plate forward.
3 Lift the bottom plate.
Drainage device (inside)
Skirt panel
Air intake inlet of the unit.
Correct installation method of honeycomb. Check the shape of the honeycomb and install it.
The correct way to install the honeycomb In the case of the shape as shown in the picture above If the installation is reversed May make cold air not pass through and become less cold.